Araldite Super Strenght Expoxy Adhesive Holds Heavy Loads Up to 150Kg 24ml

A two-part epoxy adhesive that bonds with maximum strength. Mixed product gels in 2 hours. Initial bonding is achieved in 6–8 hours, with maximum bond strength after 3 days.

Features

• Stronger than other glues due to the chemical reaction of the two parts
• Bonds a variety of surfaces
• Dries clear
• Very strong and durable bonding
• High water resistance (suitable for tiles around pools, but not below the water line  for that use Selleys Knead It Aqua)
• Forms a rigid, durable bond
• Can be used for gap filling (surfaces need not mate closely)
• Good chemical resistance
• Heat resistant
• Clamping recommended for stronger bond
• Not suitable for bonding plastics such as Polypropylene and Polyethylene
• Bond strength weakens above 80°C but is regained when temperature drops

Appearance

Translucent

Where Can This Product Be Used?

• Load-bearing repairs
• Gluing the head back on a hammer
• Fixing loose table or chair legs
• Bonding aluminium sheeting
• Bonding timber on boats
• Repairing splits and cracks in cricket bats
• Bonding fibreglass sheets
• Repairing skis
• Fixing Dynabolts and metal rods into concrete

Suitable Materials

• Glass
• Metal
• Wood
• Fabric
• Rigid plastics (except Polyethylene and Polypropylene)
• Crystal
• Leather

How to Use

• Ensure all surfaces are clean, dry, and free from grease, rust, or paint.
• For best results, roughen smooth surfaces after solvent cleaning.
• Dispense equal volumes of Part A and Part B onto a clean disposable surface (e.g. cardboard or polyethylene) and mix thoroughly.
• Apply adhesive immediately to both surfaces and press together.
• Clamp the bond for 6–8 hours while setting.
• Scrape off excess adhesive and clean utensils immediately.

Handy Tips

• Mix in small quantities for longer working time — large mixes cure faster.
• Replace caps immediately after use and wipe nozzles with acetone or nail polish remover before sealing.
• Ensure caps are placed on the correct tubes (they are colour-coded).
• Remove uncured adhesive with acetone or nail polish remover.
• Once cured, remove by mechanical scraping or sanding — solvents will not dissolve the product.
• To reposition a cured bond, heat slowly to at least 150°C (if safe for the material), then scrape off excess and reposition carefully.
• For cleaning surfaces before use:
  • Porous surfaces use Selleys Liquid Sugar Soap
  • Non-porous surfaces (e.g. glass, metal) — clean with methylated spirits
  • For stubborn residue use Selleys Kwik Strip Smart
  Ensure the surface is dry before applying.

Safety Tips

• Avoid contact with skin and eyes.
• Avoid breathing vapour.
• Do not use solvents near eyes or open wounds.
• In case of eye contact, flush with water for 15 minutes and seek medical attention.
• Non-toxic when set.
• Refer to the Material Safety Data Sheet (MSDS) for more information.

Storage & Reuse

• Replace caps tightly after use.
• Store in a cool, dry place.